ORVietVet's latest activity
-
I'd do everything. My philosophy is to build the strongest/best unit I can afford to build because I KNOW I will be hard on it. I told... -
Another vote for a 4L80e swap as @Tonimus pointed out. I did that on my 99 Silverado ECSB 2wd while I swapped from a 4.3 to a 5.3. On...
-
Left hub was bad. I doubt it would have lasted much longer.
-
If I'm going through all that, I'm going with a 4L80E. Just do a segment swap on the PCM and send it. A cost effective but decent 4L80E...
-
Could be orifice tube, could be overfilled. That's definitely incorrect.
-
Welcome! All that sounds good to make the 4L60E stronger. Nick on youtube I think is pretty knowledgeable...
-
Hey everyone I have a question about rebuilding the 2004-2006 4l60e, ive been debating on putting a performance kit/Alto rebuild kit...
-
2019 front brakes after 10k miles+...looks great!
-
-
ORVietVet reacted to idatahoe's post in the thread 2001 Tahoe high presure on low side of A/C with
Like.
Thank you for your replies! How could it be low on refrigerant with the low side getting up to 60 PSI, then the compressor clutch... -
The pressure expected is dependent on ambient temperature, so check an r134a chart. It the clutch disengages and the compressor no...
-
Decided to dig in a little more - I might be changing my plans. Looked at the scan from O’Reillys again - it actually suggested...
-
If that doesn’t do it it’s probably the tank pressure sensor.
-
Plan on doing new purge valve, vent valve & gas cap. I’ll probably blow out the lines and clean the charcoal canister as well. Is there...
-
ORVietVet replied to the thread EVAP P0446.Good videos. There have been literally millions of the purge valves sold because of it's location.
