Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Photo Gallery
Under Construction
2000 Single Cab Short Bed “DateNight”
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DateNight" data-source="post: 21196" data-attributes="member: 11473"><p>New, maybe 50miles on it. but I’m going to pull it off again and inspect it.</p><p></p><p>Oh yeah, I put a new crank shaft position sensor in it. Still didn’t fix it. </p><p></p><p>When I did the tune up I put copper plugs in it. The factory calls for platinum. So I might put the old ones back in to see if anything changes.</p><p></p><p></p><p></p><p>When I bought the truck I got it with the intention of swapping the v6. The guy I got it from was bragging on the engine being “rebuilt” etc. I knew then he was full of chit. I can 100% tell you for a fact this is a 275k mile v6 that’s never been opened up. The coil was still a factory GM coil, i had to grind the rivets down to replace it. The ground wires have never been off the block and looms never been disturbed.</p></blockquote><p></p>
[QUOTE="DateNight, post: 21196, member: 11473"] New, maybe 50miles on it. but I’m going to pull it off again and inspect it. Oh yeah, I put a new crank shaft position sensor in it. Still didn’t fix it. When I did the tune up I put copper plugs in it. The factory calls for platinum. So I might put the old ones back in to see if anything changes. When I bought the truck I got it with the intention of swapping the v6. The guy I got it from was bragging on the engine being “rebuilt” etc. I knew then he was full of chit. I can 100% tell you for a fact this is a 275k mile v6 that’s never been opened up. The coil was still a factory GM coil, i had to grind the rivets down to replace it. The ground wires have never been off the block and looms never been disturbed. [/QUOTE]
Verification
Post reply
Random media
Latest posts
Y
GMT800 diagnostic and control app
Latest: YukonDenali03
11 minutes ago
Tech Discussion
Rust free state options
Latest: FW_Z71Burb
Today at 1:40 PM
Ebay / Craigslist Finds
Suburban rear window
Latest: ORVietVet
Wednesday at 9:35 PM
Exterior
Manual seat to Electic
Latest: AuroraGirl
Wednesday at 7:38 PM
Interior
M
Gear ratio
Latest: Marky Dissod
Wednesday at 12:00 PM
Engine & Performance
Members online
YukonDenali03
Forums
Photo Gallery
Under Construction
2000 Single Cab Short Bed “DateNight”
Top