Reply to thread

Message: <blockquote data-quote="Tonimus" data-source="post: 28355" data-attributes="member: 12914">Welcome to the forum! There's no reset needed according to OEM info, but there ARE two sensors according to the book.Inside Air Temperature Sensor, Replace  Auxiliary <ol> <li data-xf-list-type="ol">Remove lefthand rear door sill trim plate.</li> <li data-xf-list-type="ol">Remove lower rear seat belt cover and bolt.</li> <li data-xf-list-type="ol">Remove lefthand third pillar trim panel and rear coat hook.</li> <li data-xf-list-type="ol">Remove rear headliner retainers from front headliner.</li> <li data-xf-list-type="ol">Lower headliner from roof retainers.</li> <li data-xf-list-type="ol">Disconnect inside air temperature sensor electrical connector.</li> <li data-xf-list-type="ol">Partially remove inside air temperature sensor from headliner, then remove sensor grille from inside air temperature sensor.</li> <li data-xf-list-type="ol">Remove inside air temperature sensor from headliner.</li> <li data-xf-list-type="ol">Reverse procedure to install.</li> </ol> Front <ol> <li data-xf-list-type="ol">Remove left windshield garnish molding.</li> <li data-xf-list-type="ol">Remove left center pillar assist handle, then the left center pillar garnish molding.</li> <li data-xf-list-type="ol">Remove left sunshade.</li> <li data-xf-list-type="ol">Pull down on headliner.</li> <li data-xf-list-type="ol">Disconnect inside air temperature sensor electrical connector.</li> <li data-xf-list-type="ol">Partially remove inside air temperature sensor from headliner, then remove sensor grille from inside air temperature sensor.</li> <li data-xf-list-type="ol">Remove inside air temperature sensor from headliner.</li> <li data-xf-list-type="ol">Reverse procedure to install.</li> </ol></blockquote>