Reply to thread

Message: <blockquote data-quote="Billyjack" data-source="post: 27118" data-attributes="member: 11820">Went to remove my bed a few weeks ago, ran into some serious resistance.  It's a 2001 GMC 2500 extended cab, 6.0.  Not too rusty at all under there, I'm very fortunate.  In any event, I went to remove the bed and could loosen all 8 bolts only so much.  They would come out about 3/8", and then there was serious resistance.  1/2" corded electric impact...no good.  1/2" drive breaker bar and socket, no good.  I mean, these things were stuck.So I'm wondering if the factory added red Loctite, and heating the bolts may be required?  I definitely don't want to snap the bolts, that would be a mess. If anyone has experience with this, I'd love some pointers.  I basically tightened everything back down and will attempt again later.Thanks for any help!</blockquote>