Reply to thread

Message: <blockquote data-quote="Mikloangelo" data-source="post: 29606" data-attributes="member: 13767">Bored over, new flat top pistons, new rings new connecting rods, grind polish and balance crank, new cam. Engine machined, heads machined. New push rods new rockers. Short block put together at machinist and i put the heads on and accessories. No fluid leaks found and sealed up tight. All fluid levels good minus the oil since its burning oil. I will pull the plugs and do compression testing as well. Probably scope it while im at it. Never done a leak down test before. Watching a few videos on it seems pretty straight forward. Just need to get the tester. Will probably change the oil to see if I see anything there as well.</blockquote>