Reply to thread

Message: <blockquote data-quote="AuroraGirl" data-source="post: 25095" data-attributes="member: 9417">The exhaust hanger on the rear of the exhaust is about to fail (likely from this failed spot no doubt) [ATTACH=full]4002[/ATTACH][ATTACH=full]4004[/ATTACH]Something to consider, your chevy badge, ive never liked the way they looked on gmt800Consider what i have done, it really improves the design to me, personally, i think you could pull it off well tooYou need a 2015-2020 silverado badge, the original part number is like 40 bucks I found mine at a bin store.You remove a single molded post on the rear of the bowtie(becuase it would be too large and doesnt assist in retaining it, but you could also drill the grille where it needs to be clearanced and then tie into the retaining method you chose if desired.  I removed mine and then used the existing lined up post to fit in the grille.  my grille would have the same retainer and badge as yours just different grille.Also, Do your wipers "flip up?"Just wondering if your truck is a 2000, if it is you most likely have hinged joints in the wipers that allow it to do so, but willl hit the rear of your hood at the edge (be careful so you dont damage paint)I find it unlikely someone doing a front end change would take the wiper arms with</blockquote>