Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Discussion
Garage
Work out of my garage/driveway
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ORVietVet" data-source="post: 24254" data-attributes="member: 9438"><p>Getting a 2005 Tahoe LS dropped off in about 15 minutes, for some easy work. Plugs, wires, ignition coils, clean MAF and clean throttle body. It is the same one I did the driver's door hinge pins on and also did the brake pedal pivot bushing on. </p><p></p><p>When I am done with it, she is gonna bring her 1991 K2500 5.7 over for oil cooler lines and adaptor fittings at the oil filter housing. New headlight assemblies and new band clamps on the add on transmission cooler rubber lines. They are not leaking now but will because of the worm gear clamps on there. Also replacing the mercury activated under hood light and the roll out engine compartment light, too. </p><p></p><p>Also gonna do a real quick look at a possible intermittent a/c inop problem. When works is cold. Recent driving, started blowing warm and then shut off and restarted the next morning and fine now since then. Only happened one time. Sneaking suspension that it is a high pressure switch. Possible clutch cycling switch at the accumulator, too.</p></blockquote><p></p>
[QUOTE="ORVietVet, post: 24254, member: 9438"] Getting a 2005 Tahoe LS dropped off in about 15 minutes, for some easy work. Plugs, wires, ignition coils, clean MAF and clean throttle body. It is the same one I did the driver's door hinge pins on and also did the brake pedal pivot bushing on. When I am done with it, she is gonna bring her 1991 K2500 5.7 over for oil cooler lines and adaptor fittings at the oil filter housing. New headlight assemblies and new band clamps on the add on transmission cooler rubber lines. They are not leaking now but will because of the worm gear clamps on there. Also replacing the mercury activated under hood light and the roll out engine compartment light, too. Also gonna do a real quick look at a possible intermittent a/c inop problem. When works is cold. Recent driving, started blowing warm and then shut off and restarted the next morning and fine now since then. Only happened one time. Sneaking suspension that it is a high pressure switch. Possible clutch cycling switch at the accumulator, too. [/QUOTE]
Verification
Post reply
Random media
Latest posts
Water intrusion in rear cargo area?
Latest: stutaeng
52 minutes ago
Interior
Rebuilding 4l60e
Latest: INW-Iron-Steel
Today at 12:28 PM
Transmission & Transfer Case
4silverado's 2004 Silverado
Latest: 4silverado
Yesterday at 3:09 PM
Under Construction
2001 Tahoe high presure on low side of A/C
Latest: CPB
Yesterday at 12:45 PM
Tech Discussion
Stutaeng's 1999 Silverado
Latest: stutaeng
Thursday at 9:26 PM
Under Construction
Members online
ORVietVet
stutaeng
99Sierra2500
Forums
General Discussion
Garage
Work out of my garage/driveway
Top