Recent content by A-Aron

  1. A

    4L60E Front pump failure.

    Ported TB was just for throttle response and idle. It's a 5.3 bored .30 over with 4.8 flat top pistons with a truck Norris cam upgraded Michigan motorsports valve train. Less than 3k miles on engine. Don't see why that was important only dynoed 315 HP and 320 tq on motor. I gap the rings for 150...
  2. A

    4L60E Front pump failure.

    Okay.. Swapped in a I6 trailblazer torque converter into my 2000 Silverado. Lost fluid 2 times cause of the line blowing off my 40k cooler, stopped both times immediately and refilled to appropriate level. Drove to my tuner to have some adjustments done for mods I added ( long tubes, ported TB)...
  3. A

    4l80e swap

    That is awesome thank you so much I will more than likely do that.
  4. A

    4l80e swap

    It is a 2wd. Yeah I have had trouble finding aftermarket ones but hey I'll keep looking unless someone on here can point me in the right direction.
  5. A

    4l80e swap

    Hello guys, I have a 2000 short box Silverado with the offset transmission crossmember instead of the typical straight crossmember. My question is, what crossmember do I need to use or buy to swap in my 4l80e transmission?
  6. A

    QA1 adjustable shocks starting point

    LOL yes, my knees felt that also. Thank you for the info ill check that site out. I'll start there and let you know how it goes. I know with the 100 shot @ a 1.5 sec delay it still spun a little off the line on stock shocks on a 2/4 drop so I'll try what you suggested and see what the truck...
  7. A

    QA1 adjustable shocks starting point

    285/50/20 hard tire @ 20-25 psi, I am running traction bars and its mostly a street truck. run a progressive 125 shot of the line. What is yellow bullet?
  8. A

    What is this part?

    any luck on finding out what the part was
  9. A

    QA1 adjustable shocks starting point

    ... I have Dubble adjustable front shocks on the front and single adjustable shocks on the rear. The instructions for the shocks state, for drag racing to set the front compression between 12-18 clicks from zero, and for rebound run 0-6 clicks. This is on every shock you buy from QA1... it's a...
  10. A

    QA1 adjustable shocks starting point

    Hello, I have a 2000 Silverado with a 4/6 drop and rear shock relocation kit running single adjustable rear qa1 shocks and qa1 Dubble adjustable front shocks. My question is, what would be a good starting point for my setting on the compression and rebound for the front shocks for the drag strip...
  11. A

    Spindle swap

    Hey guys, I have a 2000 Chevy Silverado. I just swapped 2014 + front aluminum spindles onto the front end, I'm having issues doing the tow on the truck due to either the inner tie rod or outer tie rod being too short. My question is, is there a longer inner tie rod or is there a longer outer tie...
See more

Random media

20131221 171009
image
Sliding Rear Window Project 1.jpg
Light snow
for sale pic from before I bought it
2013 09 01 00.49.37
IMG 20140430 171327
LED interior lights with added 12 inch led strips as footwell lights

Latest posts

Members online

Total: 109 (members: 3, guests: 106)
Top