Search results

  1. AuroraGirl

    HOW TO: Add fog lights to 99-02, no programming.

    Most cat eyes, some 2003 are not ALso that white grate in the openings, si that stock? is that an SS bumper thing?
  2. AuroraGirl

    I need tires

    now how many of those are OWL? or RWL? (outlined white lettering and Raised White Lettering)
  3. AuroraGirl

    I need tires

    make sure to calibrate the ebtcm to the new tire size unless you found coopers in the 245
  4. AuroraGirl

    I need tires

    also they throw defender on A LOT of tires from cars to trucks with vastly different jobs and treads, the only thing i think is consistent is they tend to have a higher tread warranty and cost a lot
  5. AuroraGirl

    Verifying that these rims fit & thoughts on looks

    you just need a tech 2. my mk808 can do it as well, autel scanner. So anyone with a mid-high range tool should be able to change it. it gives you a list of tire sizes. the list actually distinctly splits between the load range D tires on duallys and load range E on trucks without dually (1 ton)...
  6. AuroraGirl

    Verifying that these rims fit & thoughts on looks

    hub opening diameter, and older trucks how about those? I would assume the hub diameter has to be larger on newer 6 lugs
  7. AuroraGirl

    Verifying that these rims fit & thoughts on looks

    speedometer being accurate is PCM calibration The EBCM The top part is the EBCM, the thing is called the EBTCM if you have traction control JL4 (i think is the RPO) The brake lines go into the BPMV or brake pressure modulator valve which is in the middle here above that contains the motor and...
  8. AuroraGirl

    Verifying that these rims fit & thoughts on looks

    the difference forr the abs system is because theDIAMETER and THE WIDTH because the module is the same as the lowly half tons through the 1 tons (I think) Also consider the ABS only works over 4mph when the truck can accurately determine wheel speed, under 4 it simply cannot, and under 8 its...
  9. AuroraGirl

    Verifying that these rims fit & thoughts on looks

    You also need to change the tire size in the EBCM which is the ABS system This is critical for safety
  10. AuroraGirl

    Keep driving your GMT800s?

    its a reference to the facebook group of "GMT800 with threatening auras" where everyone talks Like "HOSS I PUT A BIG BLOCK IN HER, BARB DIDNT LIKE THAT GOBBLESS"
  11. AuroraGirl

    Dash Hole?

    remove cubby and you can fit more stuff in it Find thing you want to stuff in it, then use something to keep it from falling in behind there, easy with flashiing or probably aa chunk of wood etc ,
  12. AuroraGirl

    Dash Hole?

    99-02 Switches Left IP Switches Top - Traction Control - 15062589 - ACDelco #15062589 - Autotrac 4wd (NP8) - 15709327 - 4wd (NP1) – 19168767 - Power Fold Mirrors - 15062588 - Pocket - 15732033 Bottom - Cargo Lamp - 15714159 - Fog Light - 15714113 - Cargo Lamp/Fog Light - 15752869 - ACDelco...
  13. AuroraGirl

    Dead 4x4, and/or dead 4L60?

    Wait. I misremembered. Spinning the front shaft is only done because of the axle. It’s not driven normally , I apologize. If you had the wheels off the ground and the shafts both spun, the Tcase was engaged
  14. AuroraGirl

    Dead 4x4, and/or dead 4L60?

    np241 from a V suburban or blazer would be the WRONG drop. Which can be reclocked, but i bet there is other differences too maybe The tcase the OP has is also always spinning the front output, so the fact they both spin is not strange
  15. AuroraGirl

    Hard To Find or Discontinued Parts?

    Did this with my hands, only slightly too long so it was annoying to connect but nice to be able to hand form
  16. AuroraGirl

    Hard To Find or Discontinued Parts?

    Reseating them a few times is usually helpful there. Also Nicop is amazing
  17. AuroraGirl

    Best way to seal new TYC Headlights/DRLs?

    Silicone in the sun will look like ass after some time. So if it’s visible while on the truck it will eventually stand out.
  18. AuroraGirl

    Best way to seal new TYC Headlights/DRLs?

    The seals are for dust not water. You can use dielectric grease on them to make them more spongy so they don’t resist removal and rejuvenate them a bit for use. I’d avoid the silicone around the housing unless you have a water getting in problem like when you splash a hose at the housing.

Latest posts

Members online

Top