Reply to thread

Message: <blockquote data-quote="FarmerTed" data-source="post: 29935" data-attributes="member: 15541"><p>Thanks  for that. Went over the harness again,  both sides of truck. checked all connectors, even the ones you need to pull the seat valances to get at.</p><p></p><p>No pinched wires or signs of any ever being pinched anywhere. No chaffed wires, tape and loom intact until i statrted poking about. All connectors tight.</p><p></p><p>Guess I'll find the control module and check connectors there next.</p></blockquote><p></p>

Verification

Random media

DRIVER SIDE VIEW

376

4 inch old block.jpg

dayumm

IMAG1275 (1)

20210722_120425

Close up new heads and bumper lights

After 5 inch blocks and Traction Bars installed.jpg

Latest posts

GM Bearing Kit needed less than 2k miles after rear diff seal replaced
- Latest: stutaeng
- 46 minutes ago
Differential & Driveline
Added trans temp to cluster and replaced bulbs with LEDs
- Latest: FW_Z71Burb
- Yesterday at 9:01 PM
Tech Discussion
Service airbag
- Latest: AuroraGirl
- Yesterday at 4:44 PM
Audio & Electronics
M
New Torque Converter
- Latest: Marky Dissod
- Yesterday at 11:58 AM
Transmission & Transfer Case
Rust free state options
- Latest: FW_Z71Burb
- Yesterday at 11:10 AM
Ebay / Craigslist Finds

Members online

No members online now.

Total: 48 (members: 0, guests: 48)

Top