FW_Z71Burb's latest activity
-
Happy Saturday and anniversary of D-Day y’all The burb started to develop a STANK the last few days. Thought it was a dirty diaper... -
-
FW_Z71Burb replied to the thread FW_Z71Burb's 2002 Suburban Z71.That’s what I thought as well. Thanks again OR
-
Yes. I believe the only exception is either a 2wd or maybe even a shallow pan set up. I recently did a 2018 4x4 Suburban, with the 6...
-
FW_Z71Burb replied to the thread FW_Z71Burb's 2002 Suburban Z71.Right but you do have to lift the trans or use the other method you described previously?
-
Ok, the deep pan means it needs more clearance at the back area where you snake the pan out. Pull out the back and to the side at same...
-
FW_Z71Burb replied to the thread FW_Z71Burb's 2002 Suburban Z71.And yes @stutaeng @ORVietVet it is the deep trans pan
-
FW_Z71Burb replied to the thread FW_Z71Burb's 2002 Suburban Z71.Summer is here in TX. Burb gets a bath!
-
-
FW_Z71Burb replied to the thread Faint fuel smell.Pumping fine for me last two fill up’s. Guessing user error on the “bad” one. Think we’re good to go
-
Upper intermediate shaft and Wolff bearing installed today = big improvement. Going to take it for an alignment next week & going to...
-
@ORVietVet the deep pan (with the step) on the 4L60e was introduced in 1997. All GMT800 came with the deep pan AFAIK. But please...
-
You should look at the vent solenoid next to the gas tank inside the frame rail. That’s the usual cause for the clicking off at the pump
-
Also, post a pic of the bottom of the pan. To be sure of shallow or deep. Makes a difference on the filter. If the vehicle has rusted...
-
If you are unsure about the clearance, I would borrow or rent a floor jack, just in case. Sometimes you have to use small blocks of wood...
-
FW_Z71Burb replied to the thread FW_Z71Burb's 2002 Suburban Z71.Damn @ORVietVet I really appreciate the help.. I feel like this should be pinned somewhere! It’s not the shallow pan, so that’s...
-
You can unbolt the bracket that holds the linkage to the side and pop the end of the linkage off and move away for clearance. On the...
Members online
No members online now.