77Conours's 2003 Duramax ECSB Build Thread

Discussion in 'Under Construction' started by 77Concours, Nov 3, 2014.

  1. 77Concours

    77Concours Member

    Joined:
    May 1, 2014
    Messages:
    7
  2. silverado13

    silverado13 Moderator

    Joined:
    May 1, 2014
    Messages:
    1,572
    Location:
    Baton Rouge
  3. 77Concours

    77Concours Member

    Joined:
    May 1, 2014
    Messages:
    7
    Just ordered Bushwacker tailgate, and bedrail caps from a local shop. Will be here tomorrow!
     
  4. silverado13

    silverado13 Moderator

    Joined:
    May 1, 2014
    Messages:
    1,572
    Location:
    Baton Rouge
    awesome, i bet its going to dress up the truck
     
  5. 77Concours

    77Concours Member

    Joined:
    May 1, 2014
    Messages:
    7
    It covers up the dents on the bed rails lol. Not looking to hide anything when I go to sell it, just getting a toolbox for Christmas and wanted to put those on beforehand. Whole reason behind this all is for my CB radio set up.
     
  6. silverado13

    silverado13 Moderator

    Joined:
    May 1, 2014
    Messages:
    1,572
    Location:
    Baton Rouge
    where are you mounting it?
     
  7. 77Concours

    77Concours Member

    Joined:
    May 1, 2014
    Messages:
    7
    I'm mounting a 102" on my toolbox once I get it, probably going to route the coax through the firewall. I have a transmission hump mount the CB sits on. I used to run dual 4' Firestiks but wanted something different.
     
  8. silverado13

    silverado13 Moderator

    Joined:
    May 1, 2014
    Messages:
    1,572
    Location:
    Baton Rouge
    looking forward to seeing how that looks
     
  9. 77Concours

    77Concours Member

    Joined:
    May 1, 2014
    Messages:
    7
    Can't believe I haven't posted in here since November. Got a lot done to the truck over the past few months.

    -Bushwacker bed rail and tailgate caps
    -Mounted black low profile toolbox from TSC
    -New block heater cord direct from GM since my old one had a short in it
    -Mounted 102" CB whip antenna on toolbox
    -Had Glowshift boost, EGT, and fuel rail pressure installed
    -EFI Live from ATP trucks flashed
    -Found a set of PTM door handles off of an LT suburban in a junkyard (not installed yet)
    -Found a TireGate off Craigslist locally and only paid $100 light, light, light surface rust in 2 areas and it needs new mounting hardware so I can't complain

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]